Sanyo SAP-KRV94EHDX 用户手册

Temperature
/Humidity sensor

Operating box

Electrical component box pad plate 1

Electrical component
box pad plate 2

P.C.Board

Electrical
component box

Connectors

Electromagnetic 
valve coil connector

Ground wire terminal

Heat exchanger sensor

Screw for the terminal cover

Terminal cover

Inter-unit
wiring

Lower right cover

(1)

(2)

Flap

Screw (Do not forget.)

Screw cover

Screws

Front panel

Arm

Grille

Remove this cover in the
order of steps (1) and (2).

(

)

Screw for the electrical component box

(Before replacing the P.C.Board with another, remove the electrical component box from the main body and its 

cover plate.)

(1) Remove the grille.

(2) Prior to remove the electrical component box, carry out the following:

(2-1) Remove the operating box of the main body and electrical component box pad plate 1.

(2-2) Disconnect all the connectors located on the P.C.Board.

(2-3) Take wiring out of the electrical component box.

(2-4) Fold down the electrical component box pad plate 2 forward

and remove the electromagnetic valve coil connector.

(2-5) Remove the temperature/humidity sensor.

(2-6) Remove the heat exchanger sensor and 

ground wire terminal.

(2-7) Remove screws for the electrical 

component box.

(2-8) Remove the lower right cover.

(2-9) Remove the terminal cover and remove the 

inter-unit cables.

1. Fully open the front panel, pulls the front 

panel while holding its part adjacent to 
the arm, and remove the front panel.

2. Remove the screw on top right of the 

main body. Also remove the screw found 
when the screw cover is opened.

3. Push three tabs on top side of the 

ornamental panel to remove them.

4. Pull the grille forward to remove it as it is.