Regency F2402M 用户手册

Regency Freestanding Woodstove

9

All units require either the pedestal or 4 legs at-
tached to the base. The F2402M  stove requires 
either the Airmate or Rear Heat Defl ector on top 
of the stove. Clearances to combustible materials 
vary depending on whether the airmate or rear 
heat defl ector is installed, so be sure to check the 
clearance information on pages 7 and 8.

1)  The airmate sits on top of the stove with 

the slots in the sides fi tting over the curved 
defl ector on the rear stove top. See diagram 
1. Discard the Rear Heat Defl ector that is 
supplied with the unit, it is not required if the 
airmate is installed. 

2)  Center the airmate and push it forward to the 

front of the stove. The back of the airmate 
should be level with the back and sides of 
the rear heat shield. See diagrams 2 & 3.

The rear heat defl ector is supplied with the stove 
and must be installed unless the optional airmate 
has been selected. It stops the heat radiated from 
the fl ue collar from overheating the rear wall. The 
rear heat defl ector is installed on top of the rear 
heat shield, as shown in diagram 4.

1)  For easier assembly, tip the stove on its 

back (onto a soft surface to prevent scratch-
ing).

  
 

Hint: If you have chosen the Ash Drawer 
option, remove the ash dump cover plates 
before attaching the pedestal. See page 16 
"Ashdrawer Kit Installation".

2)  Remove the blanking plate if 
 a)   you are not installing outside combustion 

air or 

outside air is to be brought in from the 
rear of the stove.

3)  Unscrew the 4 bolts in the under-side of the 

stove. Align the holes in the corners of the 
pedestal top with the corresponding holes 
in the base of the stove. Fasten using a bolt 
and washer for each corner.

4)  Push the Regency logo 

into the two holes in 
the front bottom 
left corner of the 
pedestal cover 
plate.

 

 

5)  If not using ash drawer, then cover plate must 

be installed. If using ash drawer, then disregard 
cover plate.