Panasonic SC-HTB770 用户手册

RQT9778

∫ Remote control code

When other Panasonic devices respond to this system’s 
remote control, change the remote control code on this 
system and the remote control.

≥ Turn off all other Panasonic products.
≥ Turn on the main unit.

Change the remote control code to code 2:
1

Aim the remote control at the main unit’s 
remote control sensor.

2

Press and hold [MUTE] and [

] on the remote 

control for more than 4 sec.

≥ All the indicators will blink for 10 sec when the code of 

this system

 

is changed.

≥ The setting is maintained until it is changed again.

≥ If the main unit does not operate after changing the code, 

repeat steps 1 and 2.

≥ To change the remote control code to code 1, repeat the 

steps above, but replace 

[

] 

with [INPUT SELECTOR]. 

∫ To reduce the clear-mode dialog effect

When the dialog does not sound natural while the volume 
is set low, it is possible to reduce the dialog enhancing 
effect as follows:

While pressing and holding [SOUND] on the 
remote control, press and hold [s VOL] on the 
main unit for more than 4 sec.

≥ All the indicators will blink once when the clear-mode dialog 

effect is reduced.

≥ Even if clear-mode dialog effect is reduced, dialog effect 

level is still adjustable.

To reset the setting, return to the factory preset. (> 36)

∫ To turn off VIERA Link “HDAVI 

When “HDAVI Control” compatible equipment does not 
work well with this system, for example, it is possible to 
turn off this function as follows:
≥ When VIERA Link is turned off, the ARC function is not 

available. Be sure to connect the optical digital audio 
cable. (> 26)

1

While pressing and holding [MUTE] on the 
remote control, press and hold [s VOL] on the 

main unit for more than 4 sec.

2

After the setting has changed, turn off all the 
connected devices and then turn them on 
again.

≥ All the indicators will blink once when VIERA Link “HDAVI 

Control” is turned off.

To reset the setting, return to the factory preset. (> 36)

∫ To turn off the volume limitation

If a state of the lowered volume disturbs you every time 
the main unit turns on, for example, it is possible to turn off 
this function as follows:

While pressing and holding [MUTE] on the remote 
control, press and hold [VOL i] on the main unit 
for more than 4 sec.

≥ All the indicators will blink once when the volume limitation 

is turned off.

To reset the setting, return to the factory preset. (> 36)

SC-HTB770PPC_RQT9778-1P_mst.book  Page 35  Tuesday, January 29, 2013  11:33 AM