Panasonic PT-DW17KU 用户手册

 

z

For a set time after [LAMP SELECT] is switched, 

[LAMP SELECT] cannot be switched again, 

because the speed of the lamp replacement cycle 

will increase. Repeatedly switching [LAMP SELECT] 

in a short time will also increase the speed of the 

lamp replacement cycle.

 

z

The colors of the items indicate the status.

Green → Current setting

Yellow → Current setting

(When there is a lamp that cannot turn on or failed 

to turn on)

Red → Lamp that has failed to turn on

White → Any other status

 

z

When a lamp fails to turn on or has been used in 

excess of 2 000 hours

*1

 and a setting other than 

[QUAD] is selected, that lamp is turned off and 

another lamp turned on.

When a lamp fails to turn on or has been used in 

excess of 2 000 hours

*1

 in [QUAD], a lamp that has 

not been used in excess of 2 000 hours

*1

 is turned 

on.

The projector enters standby mode when all lamps 

have been used in excess of 2 000 hours

*1

.

 

z

Ensure that lamp units not to be turned on are also 

installed.

 

z

More lamps than the specified number of lamps 

light temporarily to prevent decreased illuminance 

when a lamp is switched.

*1:  500 hours when the optional accessory replacement lamp 

unit (for portrait mode) (Model No.: ET-LAD510P (1 pc), 

ET-LAD510PF (4 pcs)) is used.

The lump to be turned on can be automatically 

switched by setting a day and time. 

The degradation of the lamp due to continuous usage 

can be reduced by automatically switching the lamp 

to be turned on when using the projector continuously 

for a week or more.

1)  Press ▲▼ to select [LAMP RELAY].
2)  Press ◀▶ to switch [LAMP RELAY].

▶

z

The time setting to switch the lamp will change 

as follows each time you press the button.

3)  Press ▲▼ to select [TIME].
4)  Press the <ENTER> button.

▶

z

Enters adjustment mode (the display is 

blinking).

5)  Press ◀▶ to select [HOUR] or 

[MINUTE], and then press ▲▼ to 

(1 hour or 1 minute increments)

▶

z

The adjusted time is established.

7)  Press ▲▼ to select [DAY OF THE 

8)  Press ◀▶ to switch [DAY OF THE 

▶

z

The setting will change as follows each time 

you press the button.

 

z

The [LAMP RELAY] function is enabled when 

[SINGLE], [DUAL], [TRIPLE], or [QUAD] is selected 

in [LAMP SELECT].

 

z

When [SINGLE] or [DUAL] is selected in [LAMP 

SELECT], the lamp switches to the specified time.

When [TRIPLE] is selected in [LAMP SELECT], the 

lamp switches a total of three times every two hours 

from the specified time, and thereafter maintains 

the previous status until the specified time.

When [QUAD] is selected in [LAMP SELECT], 

three turn on at the specified time and the three 

lamps switch every two hours for a total of four 

times. Next, four lamps turn on eight hours after the 

specified time and thereafter three lamps switch 

again after the specified time.

 

z

The operating time will be the local time. (



 page 110)

 

z

Use the number (<0> to <9>) buttons on the remote 

control to directly enter the time.