Samsung SC88P 用户手册

 

maintaining the tools and filters

Vacuums dust in a wide area at once.

Remove waste matter completely from 

the inlet if the inlet is blocked.

PARQUET BRUSH (OPTIONAL)

REPLACING the Drive Belt

1. Make sure that the vacuum is unplugged.

2.  With the rotating floor brush removed from the vacuum 

cleaner, grasp the old drive belt and remove it from the 

motor pulley. Discard the old drive belt. 

3.  Place the new drive belt over the motor pulley and stretch 

the other end over the rotating floor brush in the space 

between the bristles. 

4.  Place the ends of the rotating floor brush down into the 

slots on the sides as shown. 

5.  Turn the rotating floor brush by hand several times in the 

direction of the motor pulley. If properly installed, the drive 

belt will center itself on the rotating brush crown. 

6. Reposition the brush cover and screws. Tighten the screws securely. 

CHECKING the Rotating Floor Brush and Drive Belt

You should check your vacuum cleaner’s rotating floor brush and drive belt regularly for 

wear or damage. You should also clean strings, hair, and carpet fibers off the brush and 

brush ends. These can wrap around the brush and hamper its ability to effectively clean 

your carpet. Also remove any debris that has accumulated under the brush cover.
1. Unplug the vacuum the electrical outlet.

2.  Place the handle in low position and turn the vacuum 

cleaner over so the bottom side is up.

3.  Remove the six screws (at arrows, right) with a screwdriver.

4.  Remove the brush cover from the floor brush.

5. Grasp the rotating floor brush at both ends and lift.

6.  Clean string, hair and other debris off the rotating floor 

brush, paying particular attention to brush ends.

7.  Clean string, hair and other debris off the motor pulley and 

drive belt areas.

8.  Check the drive belt carefully for wear, cuts or stressed 

areas.

9.  Check the air passageway for obstructions. Remove 

debris from this area.

The rotating floor brush could cause the fringe of a rug 

to become tangled within the vacuum.

Use caution and turn off the floor brush when 

vacuuming throw rugs with fringe.

MAINTAINING FLOOR TOOLS

DJ68-00597P(POWER)-0.0.indb   10

2012.4.16   10:28:49 AM