Samsung SC88P 用户手册

 

operating the vacuum

VACUUMING WITH THE POWER BRUSH

OVERLOAD PROTECTOR 

The hose must be plugged into the canister and the 

power brush must be plugged into the hose and 

extension wand.

•  For best results, move the power brush slowly using 

short, overlapping strokes.

•  For heavily soiled areas, repeat strokes in several 

directions.

• Push the height adjustment button to match the surface being cleaned.

• Press the height adjustment button at the bottom of the wand until it clicks.

Do not invert the power brush while it is running.

You can check whether the power brush is operating correctly by lifting up the 

extension tube slightly to view the back of the brush.

The Power Brush will not operate when it is jammed or the unit is turned off.

If the Power Brush is jammed, unplug the power cord from the electrical outlet.

Turn the power brush over and remove the jammed object.

Turn the power brush back to the vacuuming position and resume vacuuming.

The overload protector shuts off the brush motor if 

the floor brush becomes obstructed, the floor brush 

will stop, but the suction motor will continue to run. 

To reset the overload protector, turn the vacuum off 

and unplug it. Clear the obstruction from the floor 

brush area. Use a pen tip to press down the reset 

switch. Turn the vacuum on and continue cleaning.

POWER BRUSH

DJ68-00597P(POWER)-0.0.indb   8

2012.4.16   10:28:37 AM