Marantz CDR632 用户手册
1 – Introduction—What is finalizing?
7
ENGLISH
What is finalizing?
Even after audio data is recorded on a CD-R or CD-
RW disc, it cannot be played back on a conventional
CD player until the final TOC
RW disc, it cannot be played back on a conventional
CD player until the final TOC
(*)
data has been
recorded on the disc. The process of recording this
TOC data is called “finalizing”.
No further recording can be performed on a finalized
disc. However in the case of a CD-RW, the disc can be
“un-finalized” to allow additional recording (
TOC data is called “finalizing”.
No further recording can be performed on a finalized
disc. However in the case of a CD-RW, the disc can be
“un-finalized” to allow additional recording (
→
p.31).
* TOC: Table of Contents = information about the
recorded data, such as the number and playing
times of the songs
times of the songs
Using the remote control unit
Cautions for use
• Remote control operations may not be possible if
the remote control receiver is in direct sunlight or
under intense illumination.
under intense illumination.
• Please be aware that operating the remote control
unit may cause unintended operations to occur on
other infrared-controlled equipment.
other infrared-controlled equipment.
Installing the batteries
Open the cover on the back panel of the remote con-
trol unit, and install two batteries (AAA size) in the
correct orientation as indicated by the “+” and “-”
markings on the case.
trol unit, and install two batteries (AAA size) in the
correct orientation as indicated by the “+” and “-”
markings on the case.
When to replace the batteries
If the range of control has lessened, or if pressing a
button does not produce an operation, please replace
both batteries with new ones.
button does not produce an operation, please replace
both batteries with new ones.
Caution regarding batteries
Incorrect use of batteries may cause leakage or burst-
ing. Please carefully read and observe the following
cautions.
ing. Please carefully read and observe the following
cautions.
• Be sure to insert the batteries in the correct orien-
tation as indicated by the “+” and “–” markings
on the battery case.
on the battery case.
• Do not mix new batteries with old batteries, or
batteries of differing types.
• Never attempt to recharge batteries.
• Remove the batteries if you won’t be using the
• Remove the batteries if you won’t be using the
remote control unit for an extended period (more
than one month).
than one month).
• If leakage occurs, carefully wipe off any liquid
from inside the case and install new batteries.