Eureka 4380 Series 用户手册

下载
页码 11
It is clearly visible when the dust compartment is full and needs emptying. 
Lift screen as shown (3) to completely empty cyclonic cassette. It is possible 
to clean out the cyclonic cassette by using another vacuum.
CAUTION:   The cyclonic cassette can be washed in warm water, if 
desired, but strong detergents should not be used. Dry 
thoroughly before using again.
7
HOW TO MAINTAIN 
(Continued)
The instructions in this booklet serve as a guide to routine maintenance. To avoid unnecessary service calls, check the 
cyclonic cassette, belt, and brush roll often.
Check and clean the Cassette Micron Filter once a month to maintain good 
performance. The filter can be cleaned by vacuuming with another cleaner 
or brushing dust off into the trash. Recommended changing of the Cassette 
Micron Filter is once every three months.
Remove cyclonic cassette by pushing up lever (1), unhooking (2) by 
swinging outward from vacuum body. When replacing cyclonic cassette, 
hook at top where shown (2), and swing back into place until lever (1) 
snaps into place.
2
1
To Change Cassette Micron Filter:
NOTE:  Turn off the switch and unplug the electrical cord 
before changing the Cassette Micron Filter. Never 
operate the vacuum cleaner without the cyclonic 
cassette or the filter.
1. Remove the filter frame by grasping the handle on the back of 
the filter frame and pulling firmly. The filter frame will drop down 
staying connected at the hinges on the bottom.
2. Remove old filter from filter frame and replace with a new filter.
3. Reconnect filter frame to cassette body by swinging filter frame 
up and pushing against cassette body until it snaps into place.
To Change the Cassette Micron Filter:
1
2
3
1. Filter Frame
2. Filter
    
3. Cassette Body
Use GENUINE EUREKA replacement filter, 60696. 
Look for the GENUINE EUREKA product symbol.
NOTE:   The compartment with the screen (a) will fill much faster 
with larger dirt particles than the compartment with the 
cone (b). This is normal, empty the cyclonic cassette 
when the side with the screen is full, do not wait for the 
side with the cone to fill completely.
FOR INSTRUCTIONS ON HOW TO REMOVE THE CYCLONIC CASSETTE FROM THE 
CASSETTE BODY, REFER TO ABOVE.
Emptying the Cyclonic Cassette:
How To Empty Cyclonic Cassette
          NOTE: Turn off the switch and unplug the electrical cord before emptying cyclonic cassette. Never operate 
the vacuum cleaner without the cyclonic cassette or the filter.
b
a
3