ONKYO TX-NR5009 用户手册

En

With this preference, you can protect your settings by 
locking the setup menus.

■

`

`

When “Locked” is selected, the setup menus will be 
locked and you cannot change any setting.

You can change various audio settings from the Home 
menu (

).

• These settings are not available in either of the following cases:

– the  “Audio TV Out” setting is set to “On” (

).

– “HDMI Control(RIHD)” is set to “On” (

) and 

you’re listening through your TV speakers.

■

`

Stereo Source 1, Stereo Source 2, Stereo Source 3, 
Multich Source 1, Multich Source 2, Multich 
Source 3

`

With this setting, you can select the combination of 
settings that you registered in “Sound Program Edit” 
(

• This setting is not available when the multichannel analog input 

is selected.

• If the input selector is changed, the “Sound Program” setting is 

switched back to “Off”.

■

`

–10dB to 0dB to +10dB in 2 dB steps.

You can boost or cut low-frequency sounds output.

■

`

–10dB to 0dB to +10dB in 2 dB steps.

You can boost or cut high-frequency sounds output.

You can adjust the bass for the front, front wide, front 
high, center, surround, surround back and subwoofer 
speakers and treble for the front, front wide, front high, 
center, surround and surround back speakers, except when 
the Direct, Pure Audio or THX listening mode is selected.

• This setting is not available when the multichannel analog input 

is selected.

■

`

–15.0dB to 0.0dB to +12.0dB in 0.5 dB steps.

■

*1

`

–15.0dB to 0.0dB to +12.0dB in 0.5 dB steps.

■

`

–12.0dB to 0.0dB to +12.0dB in 0.5 dB steps.

You can adjust the volume of each speaker while listening 
to an input source.
These temporary adjustments are cancelled when the AV 
receiver is set to standby. To save the setting you made 
here, go to “Level Calibration” (

setting the AV receiver to standby.

• You cannot use these functions while the AV receiver is muted.
• These settings cannot be used while a pair of headphones is 

connected.

• Speakers that are set to “No” or “None” in 

) cannot be adjusted.

*1

If the “Subwoofer” setting is set to “1ch”, this setting cannot 
be selected (

).

q/w and ENTER to select “Audio”, and then 

q/w/e/r to make the desired selection.