Sony STR-DN2010 用户手册

D:\NORM'S JOB\SONY HA\SO0071\STR-DN2010\GB\GB05ENJ_STR-DN2010-CEL.fm

STR-DN2010

4-182-049-11(1)

 

 

 

 

 

 

 

 

 

Press 

V/v repeatedly to set the size of 

the selected speaker, then press 

.

• Large

If you connect large speakers that will 
effectively reproduce bass frequencies, 
select “Large”. Normally, select “Large”.

• Small

If the sound is distorted, or you feel a lack 
of surround effects when using multi 
channel surround sound, select “Small” to 
activate the bass redirection circuitry and 
output the bass frequencies of each 
channel from the subwoofer or other 
“Large” speakers.

This function does not work when “A. DIRECT” is 
being used.

• The “Large” and “Small” settings for each speaker 

determine whether the internal sound processor 
will cut the bass signal from that channel.

 

When the bass is cut from a channel, the bass 
redirection circuitry sends the corresponding bass 
frequencies to the subwoofer or other “Large” 
speakers.

 

However, since bass sound has a certain amount of 
directionality, it is best not to cut it, if possible. 
Therefore, even when using small speakers, you 
can set them to “Large” if you want to output the 
bass frequencies from that speaker. On the other 
hand, if you are using a large speaker, but prefer 
not to have bass frequencies output from that 
speaker, set it to “Small”.

 

If the overall sound level is lower than you prefer, 
set all speakers to “Large”. If there is not enough 
bass, you can use the equalizer to boost the bass 
levels.

• The surround back speakers will be set to the same 

setting as that of the surround speakers.

• When the front speakers are set to “Small”, the 

center, surround, and front high speakers are also 
automatically set to “Small”.

• If you do not use the subwoofer, the front speakers 

are automatically set to “Large”.

Lets you set the bass crossover frequency of 
speakers that the speaker size has been set to 
“Small” in the Speaker Settings menu. 
Measured speaker crossover frequency is set 
for each speaker after the Auto Calibration.

V/v repeatedly to select 

V/v repeatedly to adjust 

You can select the test tone type on the “Test 
Tone” screen.

Test tone is not output from the headphones 
connected to the S-AIR surround amplifier.

• To adjust the level of all speakers at the same time, 

press MASTER VOL +/– (RM-AAP055 only) or 

2

 +/– (RM-AAP056 only). You can also use 

MASTER VOLUME on the receiver.

• The adjusted value is shown on the TV screen 

during adjustment.

You can output test tone from the speakers in 
sequence.

Press 

B/b repeatedly to select “Test 

Tone”, then press 

.