Sony STR-DN2010 用户手册
45
GB
D:\NORM'S JOB\SONY HA\SO0071\STR-DN2010\GB\GB04GET_STR-DN2010-CEL.fm
masterpage: Right
STR-DN2010
4-182-049-11(1)
Pre
p
ar
ing the
ing the
R
eceive
r
3
Press
V/v repeatedly to select
“Auto Calibration”, then press
.
4
Press
V/v repeatedly to select
“Calibration Start”, then press
.
The screen on which you can select the
item to be measured appears.
item to be measured appears.
5
Press
V/v repeatedly and
to
uncheck the items you do not
want to measure, then press
want to measure, then press
b.
The confirmation screen, asking whether
you are ready to start measurement,
appears.
you are ready to start measurement,
appears.
6
Press
to select “Start”.
The measurement starts in five seconds.
The measurement process will take
approximately 30 seconds with a test
tone. Wait until the measurement process
completes.
When the measurement ends, a beep
sounds and the screen switches.
The measurement process will take
approximately 30 seconds with a test
tone. Wait until the measurement process
completes.
When the measurement ends, a beep
sounds and the screen switches.
Note
If an error code appears on the screen, see
“Message list after Auto Calibration
measurement” (page 48).
“Message list after Auto Calibration
measurement” (page 48).
7
Press
V/v repeatedly to select
the item you want, then press
.
To save the measurement results, follow
the steps in “3: Saving the measurement
results” (page 46).
If you want to check error code or
warning message, see “Message list after
Auto Calibration measurement”
the steps in “3: Saving the measurement
results” (page 46).
If you want to check error code or
warning message, see “Message list after
Auto Calibration measurement”
Item and explanation
Retry
Performs the Auto Calibration again.
Performs the Auto Calibration again.
Warning
Displays warning concerning the
measurement results. See “Message list after
Auto Calibration measurement” (page 48).
Displays warning concerning the
measurement results. See “Message list after
Auto Calibration measurement” (page 48).
Phase*
Displays the phase of each speaker (in phase/
out of phase).
Displays the phase of each speaker (in phase/
out of phase).
Distance
Displays the measurement result for speaker
distance.
Displays the measurement result for speaker
distance.
Level
Displays the measurement result for speaker
level.
Displays the measurement result for speaker
level.
Exit
Exits the setting process without saving the
measurement results.
Exits the setting process without saving the
measurement results.
continued