Sony STR-DN2010 用户手册

D:\NORM'S JOB\SONY HA\SO0071\STR-DN2010\GB\GB04GET_STR-DN2010-CEL.fm

STR-DN2010

4-182-049-11(1)

 

Before you perform Auto Calibration, check 
the following items. 
• Set up and connect the speakers (page 19, 

21).

• Connect only the supplied optimizer 

microphone to the AUTO CAL MIC jack. 
Do not connect other microphones to this 
jack.

• Set “Sur Back Assign” to “BI-AMP” in the 

Speaker Settings menu if you use 

 

bi-amplifier connection (page 106).

• Set “Sur Back Assign” to “SPEAKER B” in 

the Speaker Settings menu if you use 
speakers front B connection (page 41).

• Pair the surround amplifier to S-AIR main 

unit if you want to use surround amplifier.

• Make sure the speaker output is not set to 

“SPK OFF” (page 42).

• Disconnect the headphones.
• Remove any obstacles in the path between 

the optimizer microphone and the speakers 
to avoid measurement errors.

• Make sure the environment is quiet to avoid 

the effect of noise and get a more accurate 
measurement.

• Select the seating position as position 1, 2 or 

3 to save the Auto Calibration result 

 

• During the measurement, the sound that comes out 

of the speakers is very loud. The volume of the 
sound cannot be adjusted. Pay attention to the 
presence of children or to the effect on your 
neighborhood.

• If the muting function has been activated before 

you perform Auto Calibration, the muting function 
will be set to off automatically.

• The measurements may not be performed correctly 

or Auto Calibration cannot be performed when 
special speakers, such as dipole speakers are used.

If you connect front high speakers, select 
the speaker pattern that has front high 
speakers (5/x.x or 4/x.x) each time 
you perform Auto Calibration. 
Otherwise, the characteristics of the front 
high speakers cannot be measured.

Place the optimizer microphone at your 
seating position. Use a stool or tripod so 
that the optimizer microphone remains at 
the same height as your ears.

Optimizer microphone