Sony STR-DA1800ES 用户手册

D:\NORM'S JOB\SONY HA\SO120031\STR-DA1800ES_PMRF 
02\4428194122_USFR\US07ADD_STR-DA1800ES-CEL.fm

STR-DA1800ES
4-428-194-12(2)

• Bluetooth devices connected with this 

receiver must comply with the Bluetooth 
specification prescribed by the Bluetooth 
SIG, Inc., and must be certified to comply. 
However, even when a device complies with 
the Bluetooth specification, there may be 
cases where the characteristics or 
specifications of the Bluetooth device make 
it impossible to connect, or may result in 
different control methods, display or 
operation.

• Noise may occur or the audio may cut off 

depending on the Bluetooth device 
connected with this receiver, the 
communications environment, or 
surrounding conditions.

If you have any questions or problems 
concerning your receiver, please consult your 
nearest Sony dealer.

If you experience any of the following 
difficulties while using the receiver, use this 
troubleshooting guide to help you remedy the 
problem. Should any problem persist, consult 
your nearest Sony dealer. Note that if service 
personnel changes some parts during repair, 
these parts may be retained.

• “Auto Standby” is set to “ON” (page 108).
• The Sleep Timer function is working 

• “PROTECTOR” is working (page 132).

• The software update has error. Unplug the 

power cord, and then plug in the power 
cord again. The receiver will try to update 
the software. If the indicator continues to 
flash in quick succession, contact your 
nearest Sony dealer.

• The receiver is placed near equipment 

such as a television, VCR, or tape deck. 

 

If the receiver is being used in 
combination with a television, VCR, or 
tape deck, and is placed too close to that 
equipment, noise may result, and picture 
quality may suffer. This is especially likely 
when using an indoor antenna (aerial). 
Therefore, we recommend using an 
outdoor antenna (aerial).

• Phenomenon is specific to this amplifier. 

This is not a malfunction. If “Ctrl for 
HDMI”, “Pass Through”, “Network 
Standby” or “BT Standby” is set to “ON”, 
or the power for zone 2 is turned on, the 
top of the receiver may become hot even 
while the receiver is in standby mode. This 
condition occurs because current is 
flowing in the internal circuits of the 
receiver, and this is normal.

• Before connecting cords, be sure to 

disconnect the AC power cord (mains 
lead). 

• It is not necessary to connect all the cords. 

Connect according to the availability of 
jacks on the connected equipment.