Sony STR-DA1800ES 用户手册

D:\NORM'S JOB\SONY HA\SO120031\STR-DA1800ES_PMRF 
02\4428194122_USFR\US04GET_STR-DA1800ES-CEL.fm

STR-DA1800ES
4-428-194-12(2)

Depending on the position of the subwoofer, the 
measurement results may vary. However, there will 
be no problems even if you continue to use the 
receiver with that value.

The network settings for the receiver must be 
set correctly to use the Home Network, SEN, 
AirPlay, and PARTY STREAMING functions.

There are several connecting methods you can 
use to set up a wireless network: searching for 
an access point, using a WPS connecting 
method (either the push-button method or the 
PIN code method), or manual setting.

• Make sure not to use the wireless LAN function 

where medical equipment (such as a pacemaker) is 
used or where the use of wireless communication is 
prohibited.

• Before connecting to your home network, you need 

to prepare a wireless LAN router/access point. For 
details, refer to the operating instructions of the 
device.

• Depending on your home network environment, 

the wireless LAN router/access point may have 
been set up such that it cannot be connected using 
WPS, even though it is compatible with WPS. For 
details on whether your wireless LAN router/
access point is compatible or not compatible with 
WPS, and on the setup of a WPS connection, refer 
to the operating instructions of your wireless LAN 
router/access point.

• You may encounter setup difficulties if the receiver 

and the wireless LAN router/access point are 
located too far from each other. If you do, move the 
devices closer to each other.

Error Code 31
The SPEAKERS is set to off. Set to other speaker 
settings and perform the Auto Calibration again.

Error Code 32
Error Code 33
Speakers were not detected or not connected 
properly.
• None of the front speakers are connected or only 

one front speaker is connected.

• Either the surround left or surround right speaker 

is not connected.

• Surround back speakers or front high speakers are 

connected even though surround speakers are not 
connected. Connect the surround speaker(s) to the 
SPEAKERS SURROUND terminals.

• The surround back speaker is connected only to 

the SPEAKERS SURROUND BACK/FRONT 
HIGH/BI-AMP/FRONT B R terminals. When 
you connect only one surround back speaker, 
connect it to the SPEAKERS SURROUND 
BACK/FRONT HIGH/BI-AMP/FRONT B L 
terminals.

• Either the front left high or front right high 

speaker is not connected.

The optimizer microphone is not connected. Make 
sure that the optimizer microphone is connected 
properly and perform the Auto Calibration again. 
If the optimizer microphone is connected properly 
but the error code still appears, the optimizer 
microphone cable may be damaged.

Warning 40
The measurement process has completed with high 
noise level detection. You may be able to achieve 
better results if you try in a quiet environment again.

Warning 41
Warning 42
The input from the microphone is too big.
• The distance between the speaker and the 

microphone may be too close. Set them apart and 
perform the measurement again.

Warning 43
The distance and position of a subwoofer cannot be 
detected. This may be caused by noise. Try to 
perform the measurement in a quiet environment.

No Warning
There is no warning information.