Samsung 80 用户手册

1.  Fully extend the telescopic aerial.

2. Press 

the 

On / Standby button to switch on your sound system.

3. Press 

the 

DAB/FM button to select the FM band.

4.  Press and release the Auto-tune button  to cause your radio to scan 

in the direction previously scanned and stop automatically when it 
fi nds a station of suffi cient strength.

5.  After a few seconds the display will update. The display will show the 

frequency of the signal found. If the signal is strong enough and there 
is RDS data present then the radio will display the station name. After 
ten seconds the display will revert to showing the time and day.

6.  To fi nd additional stations press and release the Auto-tune button 

as before.

7.  To scan the FM band in a opposite direction rotate the Tuning control 

clockwise (to scan low frequency to high frequency) or anti-clockwise 
(to scan high frequency to low frequency) and then press the Auto-
tune button again.

8.  When the end of the waveband is reached your radio will recommence 

tuning from the opposite end of the waveband.

9. Adjust 

the 

Volume to the required setting.

10.  To switch off your sound system press the On / Standby button.

If you fi nd that an FM broadcast has a lot of background hiss, this may 
often be reduced by setting the radio into Mono reception mode for the 
current FM station. Please refer to the section "Stereo / Mono setting - FM" 
on page 27 for further details.

2,10

3

4-7

7