SonicWALL NSA 6600 用户手册

Initial Setup   |   

15

The following sections provide initial configuration information 
and instructions for connecting your Dell SonicWALL NSA 6600 
appliance for initial setup. 

•

•

•

•

1.

Using the provided Ethernet cable, connect one end of the 
cable to the computer you are using to manage the 
Dell SonicWALL NSA appliance. 

2.

Connect the other end of the Ethernet cable to the MGMT 
port on your Dell SonicWALL NSA appliance. 

Connect the AC power cord from the Dell SonicWALL NSA 
appliance into an appropriate power outlet. 

For further information regarding power requirements, refer to 

 of this 

document.

The Power LEDs on the front panel illuminate blue when the 
appliance is powered on. 

The Test LED or Alarm LED may illuminate and blink while the 
appliance performs a series of diagnostic tests. When these 
LEDs are no longer illuminated and the Power LEDs remain 
steadily lit, the Dell SonicWALL NSA 6600 appliance is ready 
for configuration. This typically occurs within a few minutes of 
turning on the power. 

If the Test or Alarm LEDs remain lit after the NSA 6600 has 
completed powering on, restart the appliance by disconnecting 
the power, waiting 1 minute, then connecting the power again. 

For a connected MGMT or X0 - X7 port, the Link LED for the 
port illuminates green or amber depending on the link 
throughput speed, indicating an active connection:

• Amber indicates 1 Gbps

• Green indicates 100 Mbps

• A unlit left LED with the right LED lit indicates 10 Mbps