Tascam MD-CD1MKIII 用户手册

Plug the headphone cord into the PHONES jack located 

under the POWER switch. Use the source selection switch 

to choose the desired source, and adjust the volume with 

the volume control. If the source selection switch is set to 

COMMON, both CD and MD sources can be monitored. 

When both decks output a signal, the monitored source 

depends on the 

COMMON?

 option setting on the SYSTEM 

menu.

When using headphones, take care not to turn the volume 

too high. Listening at high volumes for extended periods 

of time may result in permanent hearing damage.

Signals are output from both the CD and MD decks 

through the rear panel COMMON terminal and the 

headphone terminal with the source switch set to 

“

COMMON

”.

However, if both decks are outputting signals, priority 

is given to signals from the deck (

CD

 or 

MD

) set in 

COMMON?

 in the SYSTEM submenu of the CD menu.

Priority is given to the deck set in 

COMMON?

 for the 

COMMON output source.

For simple playback operation, the front panel buttons 

or the remote control buttons can be used. However, to 

ensure that the deck and disc information is properly 

shown on the display, the ‘display master’ setting must 

be selected for the deck in use. Also, when performing 

various playback operations by remote control, the 

‘remote control master’ setting must be selected for the 

deck in use. Refer to “Display master and remote control 

master” on page 22.
To prevent operation errors, we recommend that the 

display master and the remote control master be set for 

the same deck.

Select desired tracks for playback with the skip buttons 

(Â/¯) on the front panel or on the remote control. 

After selecting the track, press the PLAY buttons to start 

playback, or the READY buttons to cue the track and 

enter playback standby mode.
To restart playback from the beginning of the track in 

play, press the Â button once. To skip to the previous 

track, press Â twice.
To skip to the next track, press ¯ once.

Using the number buttons on the remote control, the 

number of the desired track can be entered directly.
Even numbers with two or three digits can be entered 

easily. For example:
Track 9: press ‘9’ and 009 will be displayed.
Track 12: press ‘1’ and ‘2’ and 012 will be displayed.
Track 103: press ‘1’ and ‘0’ and ‘3’ and 103 will be displayed.
After input, press the PLAY button to start playback, or 

the READY button to cue the track and enter playback 

standby mode.

A computer keyboard allows you to select a track number 

more easily for the 10 tracks from the beginning of the 

disc using the “direct track” function. (See “12 Using a 

computer keyboard – Direct track operation” on page 47 )

During playback or playback standby, this function 

enables the search of a desired portion within a track for 

playback.

Front panel operation: press the 

• 

/¯ search 

button continuously. Be sure to hold the button down; 

if you quickly release it, the Skip function will operate.
Remote control operation: continuously press the 

• 

/ search button.

The Search function does not operate with data CDs.