Husqvarna 465 用户手册

34 – English

The muffler is designed to reduce the noise level and to 
direct the exhaust gases away from the operator. The 
exhaust gases are hot and can contain sparks, which may 
cause fire if directed against dry and combustible 
material.

•

Loosen the screws that hold the starter against the 
crankcase and remove the starter.

•

Pull out the cord approx. 30 cm and hook it into the 
notch in the rim of the pulley. Release the recoil spring 
by letting the pulley rotate slowly backwards.

•

Undo the screw in the centre of the pulley and remove 
the pulley. Insert and fasten a new starter cord to the 
pulley. Wind approx. 3 turns of the starter cord onto 
the pulley. Connect the pulley to the recoil spring so 
that the end of the spring engages in the pulley. Fit the 
screw in the centre of the pulley. Insert the starter cord 
through the hole in the starter housing and the starter 
handle. Make a secure knot in the end of the starter 
cord.

•

Hook the starter cord in the notch in the pulley and 
turn the starter pulley about 2 turns clockwise.

Note! Check that the pulley can be turned at least a 
further 1/2 turn when the starter cord is pulled all the 
way out.

•

Lift off the pulley. See instructions under heading 
Changing a broken or worn starter cord.

•

Remove the recoil spring from inside the pulley by 
tapping the pulley lightly with its inside face 
downwards against a work bench or the like. If the 
spring pops out during fitting, wind it up again, working 
from the outside in towards centre.

•

Lubricate the recoil spring with light oil. Fit the pulley 
and tension the recoil spring.