Husqvarna 465 用户手册

36 – English

Adjustments are made by turning the screw using a 
screwdriver or combination spanner. The machine is 
supplied from the factory with the screw set to position 2. 
Turning the screw clockwise will reduce the oil flow and 
turning the screw anti-clockwise will increase the oil flow.

Recommended settings:

To keep the working temperature as low as possible the 
machine is equipped with a cooling system.

The cooling system consists of:

1

Air intake on the starter.

2

Air guide plate.

3

Fins on the flywheel.

4

Cooling fins on the cylinder.

5

Cylinder cover (directs cold air over the cylinder).

Clean the cooling system with a brush once a week, more 
often in demanding conditions. A dirty or blocked cooling 
system results in the machine overheating which causes 
damage to the piston and cylinder.

Centrifugal cleaning means the following: All air to the 
carburettor passes through the starter. Dirt and dust is 
centrifuged out by the cooling fan.

IMPORTANT! In order to maintain operation of the 
centrifugal cleaning system it must be regularly 
maintained. Clean the air intake to the starter, the fins on 
the flywheel, the space around the flywheel, inlet pipe and 
carburettor compartment.

Running problems can occur when using the machine in 
the cold and snowy conditions caused by:

•

Too low engine temperature.

•

Icing of the air filter and carburettor.

Special measures are therefore often required:

•

Partly mask the air inlet on the starter to increase the 
working temperature of the engine.

°°°°

The cylinder cover is designed so it can be adjusted for 
running in cold weather, so that preheated air from the 
cylinder can pass into the carburettor space preventing 
icing of the air filter, etc.

Bar 15": Position 1

Bar 16"-18": Position 2

Bar 20"-24": Position 3