Husqvarna CS 2512 用户手册

12 - English

 

  

Cutting needs to be planned carefully before assembling 
the saw so that it can be performed as easily as possible.

Husqvarna CS 2512 can be assembled to make either 
horizontal or vertical cuts. The saw is assembled standing 
when you wish to make vertical cuts.

The saw is assembled horizontally when the cut is to be 
made at floor height and when the cut is made in the floor.

It may be necessary to drill holes to thread the wire 
through the material to be cut.

Position the saw in an appropriate position in front of the 
planned cut. When the saw is in position, secure it by 
screwing down the anchor bolt. 

When the saw is anchored to the floor, screw down the 
adjuster feet so that the saw stands firmly.

Remember that the machine's centre of gravity (the grey 
circle) is positioned between the first and second pairs of 
adjuster feet (the adjuster feet pairs are marked 1-3) with a 
horizontal cut (A). When cutting under the machine, it is 
important that the saw is anchored well with the anchor 
bolt (b) as the adjuster feet pairs 2 and 3 must be used. 
(Adjuster feet pair 1 may rest on the sawn off section.) If 
the saw is not anchored well it will overturn when the mate-
rial supporting adjuster feet pair 1 has been cut through.

If necessary, fit idler wheels to assist the cutting process. 
Using the idler wheels allows the number of sharp corners 
that the wire must be pulled around can be reduced, 
which results in less wear to the wire at the same time as 
cutting is made easier. Using the idler wheels also lets the 
wire be guided in different directions without the need of 
moving the saw unit.

Also, use the idler wheels to capture the wire when 
finishing the cut.

1

2

3