Husqvarna CS 2512 用户手册

14 - English

 

  

5. Thread the wire around the drive wheel and out 

through the hole by the second swivel wheel. The 
swivel wheel can rotate and be locked in the required 
position by turning the marked (A) knobs.

6. Before the joints on the wire are connected, the wire 

should be twisted 1 to 2 turns per metre wire used. It is 
important to twist the wire in the same direction as it is 
spun. This is to give as even wear as possible on the 
wire’s diamond segments.

7. Lock the wire with a pin. If there are no end sleeves on 

the wire, these must be spliced on to the wire. A 
special pair of wire pliers must be used. If you are 
unsure about which model you should use, contact 
your DIMAS dealer.

8. When the wire is routed correctly it should run through 

the machine as in the figure below:

A used wire must always be run in the same 
direction, as it was previously run in order to 
prevent unnecessary wear.

Husqvarna CS 2512 is equipped with two outlets for the 
cooling water. Ideally, Husqvarna water spears can be 
connected to these. The water spears are then placed 
where the wire enters the concrete. In this way the wire 
takes water with it into the cut, which results in the 
concrete dust binding and that the wire is cooled 
efficiently.

In order for the water to cool the wire as 
intended during cutting, it is essential to adjust 
the position of the cooling water as the 
material is cut. Remember to always stop the 
machine when you do this.

In addition to the cooling water from the water spear, the 
wire is rinsed by the two swivel wheels on the machine. 
This is to keep the wire as clean as possible, which means 
that the saw can work with less friction losses and greater 
efficiency as the wire becomes cleaner.

WATER

WATER