Husqvarna 1153176-95 用户手册

English

 –

 33

The muffler is designed to reduce the noise level and to 
direct the exhaust gases away from the operator. The 
exhaust gases are hot and can contain sparks, which may 
cause fire if directed against dry and combustible 
material.

•

Loosen the screws that hold the starter against the 
crankcase and remove the starter.

•

Pull out the cord approx. 30 cm (12 inches) and hook 
it into the notch in the rim of the pulley. Release the 

recoil spring by letting the pulley rotate slowly 
backwards.

•

Undo the screw in the centre of the pulley and remove 
the pulley. Insert and fasten a new starter cord to the 
pulley. Wind approx. 3 turns of the starter cord onto 
the pulley. Connect the pulley to the recoil spring so 
that the end of the spring engages in the pulley. Fit the 
screw in the center of the pulley. Insert the starter cord 
through the hole in the starter housing and the starter 
handle. Make a secure knot in the end of the starter 
cord.

•

Hook the starter cord in the notch in the pulley and 
turn the starter pulley about 2 turns clockwise.

Note! Check that the pulley can be turned an 
additional 1/2 turn when the starter cord is pulled all 
the way out.