Husqvarna 1153176-95 用户手册

English

 –

 35

before taking any further action. If the spark plug is dirty, 
clean it and check that the electrode gap is 0.020 inch (0.5 
mm). The spark plug should be replaced after about a 
month in operation or earlier if necessary.

Note! Always use the recommended spark plug type! Use 
of the wrong spark plug can damage the piston/cylinder. 
Check that the spark plug is fitted with a suppressor.

Lubricate the bar tip sprocket each time you refuel. Use 
the special grease gun and a good quality bearing grease.

The clutch drum has a needle bearing on the output shaft. 
This needle bearing must be lubricated regularly (once a 
week). When lubricating, remove the clutch cover by 
loosening the two bar nuts. Lay the saw on its side with 
the clutch drum upwards.

Lubrication involves engine oil dripping into the centre of 
the clutch drum as it rotates.

The oil pump is adjustable. Adjustments are made by 
turning the screw using a screwdriver or combination 
spanner. The machine is supplied from the factory with 
the screw set to position 2. Turning the screw clockwise 
will reduce the oil flow and turning the screw anti-
clockwise will increase the oil flow.

Recommended settings:

To keep the working temperature as low as possible the 
machine is equipped with a cooling system.
The cooling system consists of:
1

Air intake on the starter.

2

Air guide plate.

3

Fins on the flywheel.

4

Cooling fins on the cylinder.

5

Cylinder cover (directs cold air over the cylinder).

Bar 18"-20":

Position 1

Bar 22"-26”:

Position 2

Bar 28" - :

Position 3