Husqvarna 535RX 用户手册

14 – English

The guard extension is removed easily using the spark 
plug spanner, see illustration.

•

Hook the blade guard/combination guard (A) onto the 
fitting on the shaft and secure with the bolt. 
CAUTION!  Ensure that the guard extension is 
removed.

Use the recommended blade guard. See the 
Technical data section.

•

Fit the drive disc (B) on the output shaft.

•

Turn the blade shaft until one of the holes in the drive 
disc aligns with the corresponding hole in the gear 
housing.

•

Insert the locking pin (C) in the hole to lock the shaft.

•

Place the blade (D), support cup (E) and support 
flange (F) on the output shaft.

•

Fit the nut (G). The nut must be tightened to a torque 
of 35-50 Nm (3.5-5 kpm). Use the socket spanner in 
the tool kit. Hold the shaft of the spanner as close to 
the blade guard as possible. To tighten the nut, turn 

the spanner in the opposite direction to the direction 
of rotation (Caution! left-hand thread). 

•

Remove the mounting plate (H). Fit the adapter (I) and 
bracket (J) with the two screws (K) as shown. Fit the 
blade guard (A) to the adapter using the 4 screws (L) 
as shown.

CAUTION! Use the recommended blade guard. See 
the Technical data section.

•

Fit the drive disc (B) on the output shaft.

•

Turn the blade shaft until one of the holes in the drive 
disc aligns with the corresponding hole in the gear 
housing.