Husqvarna 535RX 用户手册

English

 –

 15

•

Insert the locking pin (C) in the hole to lock the shaft.

•

Place the blade (D) and support flange (F) on the 
output shaft.

•

Fit the nut (G). The nut must be tightened to a torque 
of 35-50 Nm (3.5-5 kpm). Use the socket spanner in 
the tool kit. Hold the shaft of the spanner as close to 
the blade guard as possible. To tighten the nut, turn 
the spanner in the opposite direction to the direction 
of rotation (Caution! left-hand thread). 

•

When loosening and tightening the saw blade nut, 
there is a risk of injury from the teeth of the saw blade. 
You should therefore always ensure that your hand is 
shielded by the blade guard when doing this. Always 
use a socket spanner with a shaft that is long enough 
to allow this. The arrow in the diagram shows the area 
where you should operate the socket spanner when 
loosening or tightening the nut.

•

Fit the trimmer guard/combination guard (A) intended 
for use with the trimmer head/plastic blades. 
CAUTION!  Ensure that the guard extension is fitted.

Hang the trimmer guard/combination guard (A) on the 
two hooks on the plate holder (M). Bend the guard 
around the shaft and tighten it with the bolt (L) on the 
opposite side of the shaft. Use the locking pin (C). 

Place the locking pin in the groove on the screw head 
and tighten. See diagram.

•

Fit the drive disc (B) on the output shaft. 

•

Turn the blade shaft until one of the holes in the drive 
disc aligns with the corresponding hole in the gear 
housing.

•

Insert the locking pin (C) in the hole to lock the shaft.

•

Screw on the trimmer head/plastic blades (H) in the 
opposite direction to the direction of rotation.

•

To dismantle, follow the instructions in the reverse 
order.

H

H