Ryobi RY26500 用户手册

7 — English

This product requires assembly.


  Carefully remove the product and any accessories from 

the box. Make sure that all items listed in the packing list 
are included.



  Inspect the product carefully to make sure no breakage 

or damage occurred during shipping.



  Do not discard the packing material until you have care-

fully inspected and satisfactorily operated the product.



  If  any  parts  are  damaged  or  missing,  please  call 

1-800-860-4050 for assistance.

CS26
Trimmer Assembly
Dual Spool

™

 Fixed Line String Head Insert

Front Handle
Curved Shaft Grass Deflector
Bottle of 2-Cycle Lubricant
Operator’s Manual

SS26
Trimmer Assembly
Dual Spool

™

 Fixed Line String Head Insert

Front Handle
Straight Shaft Grass Deflector
Bottle of 2-Cycle Lubricant
Operator’s Manual

bC26
Brushcutter Assembly
“J” Handle
Straight Shaft Grass Deflector
Shoulder Harness
Gear Head Locking Tool
Dual Spool

™

 Fixed Line String Head Insert

Arbor
Bump Feed String Head
Spool Retainer
Bottle of 2-Cycle Lubricant
Operator’s Manual

If any parts are damaged or missing do not operate this 
product until the parts are replaced. Failure to heed this 
warning could result in serious personal injury.

Do not attempt to modify this product or create acces-
sories not recommended for use with this product. Any 
such alteration or modification is misuse and could result 
in  a  hazardous  condition  leading  to  possible  serious 
personal injury.

To prevent accidental starting that could cause serious 
personal injury, always disconnect the engine spark plug 
wire from the spark plug when assembling parts.

Never  install,  remove,  or  adjust  any  attachment  while 
power head is running. Failure to stop the engine can 
cause serious personal injury.

The attachment connects to the power head by means of 
a coupler device.


  Loosen the knob on the coupler of the power head shaft 

and remove the hanger cap from the attachment.



  Push in the button located on the attachment shaft. Align 

the button with the guide recess on the power head coupler 
and slide the two shafts together. Rotate the attachment 
shaft until the button locks into the positioning hole.

 

NOTE: If the button does not release completely in the 
positioning  hole,  the  shafts  are  not  locked  into  place.  
Slightly rotate from side to side until the button is locked 
into place.



  Tighten the knob securely.

Be certain the knob is fully tightened before operating 
equipment; check it periodically for tightness during use 
to avoid serious personal injury.

For removing or changing the attachment:


  Loosen the knob.



  Push in the button and twist the shafts to remove and 

separate ends.