Ryobi RY26500 用户手册

8 — English

See Figure 3.
There are two ways to hang your attachment for storage.
 To use the hanger cap, push in the button and place the 

hanger cap over end of the lower end attachment shaft. 
Slightly rotate the cap from side to side until the button 
locks into place.

  The secondary hole in the attachment shaft can be used 

for hanging purposes as well.

See Figure 4.


  Remove  wing  nut,  washer,  and  bolt  from  the  front 

handle.



  Install the front handle onto the top side of the drive shaft 

housing in the area indicated by the label.

  

NOTE:  The  open  side  of  the  handle  should  face  the 
operator. 



  Place the bolt through the front handle.

 

NOTE: The hex bolt head fits inside the hex recess molded 
into one side of the handle.



  Reinstall the washer and wing nut.



  Tighten wing nut securely.

See Figure 5.
A “J” handle must be used for ensuring the best control and 
maximizing operator safety when using a brushcutter.


  Place the bottom J-handle clamp on the drive shaft as 

shown. Insert the tab on the top J-handle clamp into the 
slot on the bottom J-handle clamp. 



  Insert the end of the J-handle between the clamps so that 

holes align and handle will be located to the operator’s 
left.



  Push the bolt through the clamp and handle.



  Install flat washer, lock washer, and wing nut to hold the 

assembly in place.



  Adjust the position of the handle to the area indicated by 

the label on the drive shaft housing.



  Tighten the wing nut securely.

The line cutting blade on the grass deflector is sharp. 
Avoid  contact  with  the  blade.  Failure  to  avoid  contact 
can result in serious personal injury.

See Figure 6.


  Remove hex screw, flat washer, and wing nut from grass 

deflector.



  Press the grass deflector onto the bottom of the curved 

shaft as shown.



  Insert the hex screw through the grass deflector and the 

bracket on the curved shaft.



  Place the flat washer on the hex screw.



  Place  the  wing  nut  on  the  hex  screw  and  tighten 

securely.

See Figure 7.


  Remove the wing screw from the grass deflector.



  Insert the tab on the mounting bracket in the slot on the 

grass deflector.



  Align  the  screw  hole  in  the  mounting  bracket  with  the 

screw hole in the grass deflector.



  Insert the wing screw through the mounting bracket and 

into the grass deflector.



  Tighten the screw securely.

See Figure 8.
The  guard  is  shipped  installed  on  these  brushcutter 
models. Instructions have been included for reference when 
changing from string trimmer operation back to brushcutter 
operation.


  With the string head removed, place the brushcutter guard 

on the gear head as shown.



  Install the three hex head screws from bottom through 

the guard and into the gear head.



  Tighten the screws securely and torque to 40-50 in.lb. 

minimum.

See Figure 9.


  Connect the latch on the shoulder harness to the strap 

hanger.



  Adjust the strap to a comfortable position.

To convert from the brushcutter to the string trimmer, remove 
the blade and brushcutter guard, attach the straight shaft 
grass deflector and install the string head.