Husqvarna XOUS2009 用户手册

8

1.  Remove the discharge chute from the deck. (Deck

configuration will vary by size and model)

2.  Lower deck to the lowest cutting position.
3.  Remove the right hand (discharge side) belt cover

from the deck.

4.  Relieve the tension from the deck belt and remove

from the center deck pulley.  

(See Operator’s Manual if necessary)

ASSEMBLY

Outer Pulley Cover

Pin

Hairpin Cotter

Rear Mount Bracket

Contact Area

5.  Remove the nut securing the right hand deck

pulley to the spindle.

6.  Install drive pulley included in collection system kit

on top of the current deck pulley.

7.  Reinstall the nut on the spindle and torque to 55-

75 ft/lbs.

8.  Reinstall the deck belt.

Deck Height

Adjustment

Belt Cover

Discharge Chute

Drive Pulley

1.  Position blower over the discharge tabs on the 

deck and set blower onto the deck.

2.  Be sure the blower is sitting flush against the

outside of the deck.

3.  Install the front mount bracket to the deck with the

pin and hairpin cotter supplied with the kit.