Husqvarna 953210103 用户手册

English

 – 11

•

Loosen the two screws on the fan’s outlet pipe and 
remove the two wear ring halves located on the outlet 
pipe.

•

Place these on the pipe bend so that the guide on the 
wear ring halves aligns with the slot on the pipe bend.

•

Refit the pipe bend with the wear halves in the fan’s outlet 
pipe. Make sure the holes in the wear ring halves align 
with the screws that are used to secure the halves in the 
pipe bend.

•

 Also pay attention to the stops located on the pipe bend 
and the fan’s outlet pipe. Ensure that the stop on the pipe 
bend comes in front of the stop on the outlet pipe.

•

Refit the bolts and tighten well. Check that the control pipe 
is in the right position and can rotate equally in both 
directions.

•

Disassemble the knob from the control handle and push 
the holder on to the control pipe.

•

 Assemble the knob and adjust position and angle to 
achieve comfortable working position, tighten the knob. 
Attach the cabling in the cover.

Connect the intermediate pipe and air nozzle. Push the pipes 
together and turn them so they lock in relation to one another.

Disassemble the intermediate pipe. Disassemble the knob 
from the holder and puch the holder on to the holder pipe. 
Assemble the knob and tighten.

 Assemble the intermediate pipe.

•

If higher air speed is required, the round blow pipe is 
replaced by the flat nozzle.