Exabyte 1X7 LTO 用户手册

O

CTOBER

 2006

After the door closes, and the autoloader checks the cell to verify that the 

cartridge has been removed. The autoloader also scans the affected cell to 

update its cartridge inventory. The cell selection screen appears again with 

the next available cell number:

You can continue removing cartridges in the same manner until you have 

removed as many cartridges as necessary.

8.

8.

8.

8.

Press 

 (as needed) to return to the Home screen.

If you need to remove cartridges from the autoloader when power is 

unavailable, either due to a general power failure or a failure of the 

autoloader’s power supply, you can operate the cartridge access port door 

manually. The autoloader has a small hole in the faceplate that allows access to 

a gear shaft attached to the cartridge access port door (see 

). Using a 

#0 Phillips screwdriver, you can turn the gear shaft to open the cartridge 

access port door.

If a cartridge is loaded in the tape drive when power to the autoloader fails 

and you need to remove that cartridge, you must remove the tape drive 

from the autoloader (see 

 for instructions). If the autoloader’s 

power supply failed, you can attach the tape drive to another power 

source, such as an available power connector in a server and use the tape 

drive’s unload button to remove the cartridge. If a general power failure 

occurred, contact Exabyte Technical Support (see 

) for information 

about removing the cartridge from the tape drive manually.

E x p o r t

C a r t r i d g e

F r o m

C e l l

#

n

Access hole for operating the

cartridge access port door