Exabyte 1X7 LTO 用户手册
68
P
RODUCT
M
ANUAL
1012581
C
HAPTER
5—A
UTOLOADER
O
PERATION
To remove cartridges from the autoloader without power:
1.
1.
1.
1.
Carefully insert a #0 Phillips screwdriver into the access hole on the front
of the autoloader (see
). Make sure that the screwdriver engages
the head of the gear shaft.
2.
2.
2.
2.
Turn the gear shaft counter-clockwise to open the cartridge access port
door.
3.
3.
3.
3.
When the door is fully open, remove cartridges by hand from the
autoloader. To move cartridge cells into position in front of the door,
carefully rotate the cartridge carousel with your fingers.
4.
4.
4.
4.
When you are finished removing cartridges from the autoloader, close the
cartridge access port door by turning the gear shaft clockwise.
L
OADING
AND
U
NLOADING
C
ARTRIDGES
IN
THE
T
APE
D
RIVE
During normal operation, you do not need to instruct the autoloader to load
and unload cartridges in the tape drive. Your backup software controls these
functions. However, you can use the operator panel to load and unload
cartridges, if necessary. You may want to use these functions for testing
purposes or for cleaning the tape drive (see
).
L
OADING
A
C
ARTRIDGE
INTO
THE
T
APE
D
RIVE
Before you can load a cartridge into the tape drive, the autoloader must
already contain a cartridge or you must insert a cartridge through the
cartridge access port, as described on
.
To load a cartridge into the tape drive:
1.
1.
1.
1.
At the Home screen, press
,
,
, or
to access the main menus.
If necessary, enter the operator panel password (see
).
2.
2.
2.
2.
Press
or
until the Command menu appears:
3.
3.
3.
3.
Press
to see the menu selections.
4.
4.
4.
4.
Press
or
until the following screen appears:
S e l e c t
a
C o m m a n d
L o a d
D r i v e