Yazoo/Kees ZMKH61252 用户手册

English

-

40

MAINTENANCE

Grease housings once weekly or every 40 to 50 hours 

of use. Use a good synthetic grease. Pump grease in 

until a small amount purges from the poppet on the 

underside of the deck. Check the torque of the pulley 

bolt (45 ft/lbs) should be maintained. 

Visually check that no damage is found on the lever, 

links, or switch belonging to the parking brake. Perform 

a test drive and check that there is sufficient braking 

action.
To adjust the parking brake, contact the Yazoo/Kees 

service workshop.

Check every 100 hours of operation. Check for severe 

cracking and large nicks. 

NOTE:   The belt will show some small cracks 

in normal operation.

To replace belt:

 Lower the deck to its lowest position. Remove 

1. 

the foot plate and belt shields.

 Use a ratchet with a 

2. 

9

/

16

" socket on the spring 

idler bolt to relieve the tension on the belt. 

 Slide the belt off the pulley and remove the belt. 

3. 

 Reverse the procedure for installation. See 

4. 

the decal on the top of deck for belt routing 

information.

 After installation is complete check the belt for 

5. 

twists.

Check belt every 100 hours for excessive wear. 
To replace belt, relieve tension on the deck belt 

and remove deck belt from clutch. (See deck belt 

instructions on previous page.) Loosen bolt on the 

clutch tie down and rotate out of the way. Using a ½" 

drive ratchet inserted into the square hole in the pump 

idler arm relieve the tension on the pump belt and 

remove belt. 
To reinstall belt, swing pump idler pulley out toward 

engine to route belt around it. Route belt around right 

the pulley for the left side first (right hand pulley in the 

illustration).
Reinstall idler spring and use the ratchet to rotate idler 

so the belt may be installed all the way around the last 

pulley. 

8058-007

8011-623

8011-624