Yazoo/Kees ZMKH61252 用户手册

English

-

42

MAINTENANCE

Position the mower on a level, preferably 

1. 

concrete, surface.
Check the pressure in all four tires. See 

2. 

“Technical Data”.
Rotate blades to align front to back.

3. 

Set the cutting height to 4".

4. 

Measure front blade tip, should be 4" from 

5. 

ground, if not turn locknut on top of front 

eyebolt till measurement is achieved. Check 

blade tip at front on opposite front blade. Adjust 

locknut on front eyebolt as necessary.
Check rear blade measurement, should be 

6. 

4¼" from ground. If not, turn the locknut on 

the top of the rear eyebolt to achieve the 

measurement. Repeat procedure on opposite 

side.

Cutting height adjustments
1. 

Raise and secure the deck height lever to the 

transport position. 

2. 

Position blade tip so it is straight forward.

3. 

Measure from the cutting edge of the blades 

to a flat level surface.

4. 

Drop and secure the lever at (for example) 

the 2" cutting height. Measure as above. The 

distance should be 2" (50 mm).

Anti-scalp rollers
Anti-scalp rollers are properly adjusted when they are 

just slightly off of the ground when the deck is at the 

desired cutting height in the operating position. Anti-

scalp rollers then keep the deck in the proper position 

to help prevent scalping in most terrain conditions.
The anti-scalp rollers can be set in three positions.
Upper position 1.5" to 3" (38 to 76 mm) grass.
Middle position 3" to 4.5" (76 to 114 mm) grass. 
Lower position 4.5" to 6" (114 to 152 mm) grass. 

8011-601