Husqvarna GTH2654 用户手册

Your new tractor has been assembled at the factory with exception of those parts left unassembled for shipping purposes.  
To ensure safe and proper operation of your tractor all parts and hardware you assemble must be tightened securely.  Use 
the correct tools as necessary to insure proper tightness.

A socket wrench set will make assembly easier.  Stan dard 
wrench sizes are listed.
(1)  9/16" wrench 

(1)  Tire pressure gauge

(2)  1/2" wrenches 

(1)  Utility knife

(1)  3/4" wrench 

(1)  Pliers

 

 

When right or left hand is mentioned in this man ual, it means 
when you are in the operating po si tion (seated be hind the 
steer ing wheel).

•      Remove all accessible loose parts and parts cartons  

from carton.

•     Cut along dotted lines on all four panels of carton. 

Remove end panels and lay side panels fl at.

•      Remove mower and packing materials.
•     Check for any additional loose parts or cartons and 

remove.

•      Lift hood to raised position.
•      If this battery is put into service after month and year 

indicated on label (label located between terminals) 
charge battery for minimum of one hour at 6-10 amps. 
(See "BATTERY" in MAINTENANCE section of this 
manual for charging instructions).

02173

Seat position should be adjusted forward or backward so 
that the operator can comfortably reach clutch/brake pedal 
and safely operate the tractor.  

•     Remove locknut and large fl at wash er from steering 

shaft.

•      Position front wheels of the tractor so they are pointing 

straight forward.

•      Slide the steering sleeve over the steering shaft.
•     Position steering wheel so cross bars are horizontal 

(left to right) and slide onto steering wheel adapter.

•     Secure steering wheel to steering shaft with locknut 

and large fl at wash er pre vi ous ly removed.  Tight en 
securely.

•     Snap steering wheel insert into cen 

ter of steering 

wheel.

•     Remove protective materials from tractor hood and 

grill.

IMPORTANT: CHECK FOR AND REMOVE ANY STAPLES IN 
SKID THAT MAY PUNCTURE TIRES WHERE TRACTOR IS TO 
ROLL OFF SKID.

028

18