Husqvarna GTH2654 用户手册

02521

NOTE: You may now roll or drive your tractor off the skid. 
Follow the ap pro pri ate instruction below to remove the 
tractor from the skid

.

•      Press lift lever plunger and raise attachment lift lever 

to its highest po si tion.

•      Release parking brake by de press ing brake ped al.
•     Place freewheel control in "trans mis sion dis en gaged 

position" (See “TO TRANS 

PORT” in the Op 

er a tion 

section of this manual).

•      Roll tractor forward off skid.

  WARNING: Before start ing, read, un der stand and fol low 

all in struc tions in the Op er a tion section of this man u al. Be 
sure tractor is in a well-ventilated area. Be sure the area in  
front of tractor is clear of other peo ple and objects.
•      Be sure all the above assembly steps have been com-

pleted.

•      Check engine oil level and fi ll fuel tank with gasoline.
•     Place freewheel control in "trans 

mis sion en 

gaged" 

po si tion (see "TO TRANSPORT" in Op er a tion section 
of this manual).

•      Sit on seat in operating position, depress brake pedal 

and set the parking brake.

•      Press lift lever plunger and raise attachment lift lever 

to its highest position.

•         Start the engine. After engine has started, move throttle 

control to idle position.

•      Release parking brake.
•      Slowly move the mo tion control lever for ward and slowly 

drive tractor off skid.

•      Apply brake to stop trac tor, set park ing brake and place 

motion con trol lever in neutral po si tion.

•      Turn ignition key to "STOP" position.

Continue with the in struc tions that follow.

•     Remove the two (2) bolts and fl at washers securing 

the seat to cardboard packing. Keep the two (2) bolts 
only and place them with the two (2) identical bolts 
and four (4) washers in the parts bag. Discard the fl at 
washers and cardboard packing.

•      Release L.H. seat slide  on seat pan by pulling out on 

adjustment handle and sliding it to the rear position 
exposing seat mount ing holes from bot tom. Slide R.H. 
slide to same rear position.

•      Mount rear of seat on slides using mount ing bolts and 

lock washers as shown. 

•         Pull out on adjustment handle and slide seat all the way 

forward. Install front mounting bolts and lock washers. 
Tight en all mounting bolts securely.

•         Lower seat into operating position and sit on seat. Press 

clutch/brake pedal all the way down. If operating posi-
tion is not comfortable, adjust seat.

•      To adjust seat: Grasp adjustment handle and pull out, 

slide seat to desired po si tion and release adjustment 
handle.

The gauge wheels are designed to keep the mower deck 
in proper position when operating mower.  
•      Slide gauge wheel bar down into bracket channel, Be 

sure that gauge wheel bar aligning holes are on top. 
As sem ble gauge wheels as shown using shoulder bolts, 
3/8 washers and 3/8-16 center locknuts and tighten 
securely.

•         For ease of mower to tractor as sem bly, set all the gauge 

wheels in the fourth hole from top. Retain with clevis 
pins and spring retainers.