Husqvarna EZF 3417/ 965879301 用户手册

English

MAINTENANCE

Mower Deck Adjustments

WARNING!
Before performing any service or adjustment, check the following list:
1. Engage the parking brake.

2. Place the blade switch in the disengaged position.

3. Turn ignition switch to “OFF” position and remove the key.

4. Make sure the blades and all moving parts have completely stopped.

5. Disconnect the spark plug wire from all spark plugs and place the wire

where it cannot come in contact with the plug.

WARNING!
Blades are sharp. Protect

your hands with gloves and/

or wrap blades with a heavy

cloth when handling.

1. Front Lift Arm
2. Chain
3. Rear Lift Arm
4. Slotted Deck Hanger Plates
Leveling mower deck

deck adjust

Check the tire pressure before adjustment of the

mower deck. See “Checking Tire Pressure” in

Maintenance section.

Faulty mower deck adjustments

will cause an uneven mowing result.

To level deck
Adjust the deck while the mower is on a level surface.

Make sure the tires are inflated to the correct pressure.

See “Technical Data” under Transmission. If tires are

under or over inflated, you cannot properly adjust your

deck.
Four slots control the height and pitch of the mower

deck. The deck should be adjusted slightly higher in

the rear.

NOTE: To insure accuracy of leveling proce-

dure, mower deck drive belt must be

installed prior to leveling deck.

1. Wear heavy gloves. Turn each outer blade

tip to align with the deck or in a side-to-side

manner.

2. Measure from the floor surface up to the

bottom of the blade tip on the discharge side of

the mower deck.

Retain this measurement. Move to the opposite

side, check that measurement is the same. If

adjustment is required, loosen the locknut and

move mounting bolt up or down in slot until

both side-to-side measurements are equal.

Retain measurement.