Husqvarna EZF 3417/ 965879301 用户手册

English

-

42

MAINTENANCE

Nose rollers are properly adjusted when they are 

just slightly off of the ground when the deck is at the 

desired cutting height in the operating position. Nose 

rollers keep the deck in the proper position to help 

prevent scalping in most terrain conditions.

 Adjust the deck to the desired cutting 

• 

height (see “TO ADJUST DECK CUTTING 

HEIGHT” in the operation section of this 

manual).

 Using a 

• 

9

/

16

" wrench, remove the nut and 

shoulder bolt from the nose roller.

 Lower the roller to the ground, and raise it 

• 

up to the next highest hole.

 Replace and tighten the nut and shoulder 

• 

bolt.

Be sure to readjust the nose roller if the cutting height 

is changed.

1. Bolt
2. Nut
Nose roller

3.  Turn both outer blades to align with the deck in 

front-to-rear manner. Reposition rear mounting 

bolts up or down until rear of mower deck is 

positioned level to 

1

/

8

" higher in the rear than 

the side-to-side measurement.

4.  Confirm measurements once again. Blade tips 

should be level in a side-to-side manner. In the 

rear, blade tips should be level to 

1

/

8

" higher 

than side-to-side measurement. In the front, 

blade tips should be level to 

1

/

8

" lower than 

side-to-side measurement.

NOTE:   This  will  place  the  mower  deck  in 

a  base  measurement  position. Ad-

ditional  adjustment  may  be  required 

to achieve desired cut for the type of 

grass or conditions being mowed.

1

2