Husqvarna 230 ACX 用户手册

34 - English

•

The route to a remote area is long or 
complicated.

When Automower shall follow the boundary wire 
to or from a remote area and the route along the 
boundary wire to the area is long or complicated.

•

The boundary wire runs across a long slope 
(steeper than 10 %).

When Automower follows the boundary wire 
across a slope (steeper than 10 %) the mower 
must compensate for the slope. The mower then 
follows the boundary wire at a slower speed. The 
risk of the mower running outside of the working 
area due to skidding increases.

•

The charging station is positioned on an island.

When there is more than 4 metres between the 
charging station and the outer edge of the 
boundary wire, it can take a long time for 
Automower to find the charging station when it 
follows the boundary wire. There is a risk of the 
mower following the outer edge of the working 
area 2 - 3 turns before it changes direction and 
starts to follow the loop at another spot.

In the text below the guide wires are called guide 1 and 
guide 2, as is the case on the rear of the charging 
station (220 AC only has guide 1). 

1.

Check that the charging station has the best 
placement.

The guide wire together with the part of the 
boundary wire that makes up the return to the 
charging station is known as the guide loop. The 
current in the guide loop always goes to the left 
in the connection between the guide wire and the 
boundary wire.

The adjoining picture shows what is considered 
a guide loop.

The picture is also a good example of an ideal 
position for the charging station to give the 
shortest possible guide loop.

 3012-737

 3012-738

 3012-651