Husqvarna 230 ACX 用户手册

English - 57

This function allows you to check the mower’s 
signal reception from the boundary wire, and to 
determine exactly where in the lawn the 
boundary wire is routed.

The sensor used for this function sits concealed 
directly under the catch button for the cutting 
height adjustment cover. The sensor detects the 
position of Automower in relation to the loop. 
Inside, Outside or No loop signal are shown on 
the display. If the mower is inside the loop, Inside 
is shown, etc. If the mower is set with sound on, 
a constant beep is also heard when the mower is 
outside and a pulsating beep when it cannot 
detect a signal. If the mower is inside the loop no 
beep is heard.

To:

• Check the signal reception: Move the cursor to 

Check loop and press YES.

• Find wire: Move Automower over the outer edge 

of the working area and select Check loop. 
Repeat until you find the boundary between 
Inside and Outside. You now know where the 
wire is.

The front of Automower always passes the 
boundary wire by a specific distance before the 
mower turns. The default distance is 27 cm, but 
this can be changed if required. The minimum 
value is 15 cm and the maximum value is 50 cm.

To adjust the distance: Move the cursor to Drive 
past wire and press YES. Now specify the 
number of centimetres you want Automower to 
pass the boundary wire.

3-4

3-4-1

3-4

3-4-2