Husqvarna 260 ACX 用户手册

English - 15

This chapter describes how you install Husqvarna 
Automower

®

. Before starting the installation read the 

previous chapter 2. Presentation.

Read the whole of this chapter too before starting the 
installation. How the installation is made also affects 
how well Automower

®

 will work. It is therefore 

important to plan the installation carefully.

Planning is simplified if you make a sketch of the 
working area, including all obstacles. This makes it 
easier to see the ideal positions for the charging 
station, boundary wire and guide wire, if used. Draw on 
the sketch how the boundary wire and the guide wire, if 
used, should be routed. 

3.1 Preparations.

3.2 Installation of the charging station.

3.3 Charging the battery.

3.4 Installation of the boundary wire.

3.5 Connecting the boundary wire.

3.6 Checking the installation.

3.7 Linking Automower® to the charging station.

3.8 Installation of the guide wire.

To carry out a complete start-up of Automower

®

 the 

charging station must be in position and connected, 
the boundary wire connected, and the mower 
connected to the charging station. If you would like to 
start the mower without having completed the full 
boundary installation, you can connect a temporary 
short loop around the mower.

1.

If the lawn in the proposed working area is taller 
than 10 cm, mow it using a normal lawn mower. 
Then collect the clippings.

2.

Read carefully through all the steps before the 
installation.

3.

Check that all parts for the installation are 
included:

The numbers in brackets refer to the detail 
diagram 2.1 Automower®, what’s what? on 
page 9.

• Operator’s Manual (27)

• Automower

®

• Charging station (16)

• Transformer (20)