Husqvarna 210 C 用户手册

 

20 - English

 

If a high obstacle, for example a wall or fence, 
borders the working area, the boundary wire should 
be laid 35 cm from the obstacle. This will prevent 
Automower from colliding with the obstacle and 
reduce body wear.

If the working area borders against a small ditch, for 
example, a flower bed or a small elevation, e.g. a low 
verge (3 - 5 cm), the boundary wire should be laid 
30 cm inside the working area. This prevents the 
wheels from driving into the ditch or up onto the 
verge.

If the working area borders against a flat path or the 
like that lies level with the lawn, it is possible to allow 
Automower to run a little over the path. The boundary 
wire should then be laid 10 cm from the edge of the 
path.

When the working area is divided by a flat slab path 
that is level with the lawn, it is possible to allow 
Automower to run over the path. It can be an 
advantage to lay the boundary wire under the slabs. 
The boundary wire can also be laid in the joint 
between the slabs.

 

Note! 

 

Automower must never run over a gravel path 

or similar material, which can damage the blades.

If the working area borders against, for example, 
pools of water the boundary wire should be 
supplemented with a fence or the like. The height must 
then be at least 15 cm. This will prevent Automower, 
under any circumstances, coming outside of the 
working area.

3012-760

3012-761

3012-762

3012-763