Husqvarna 210 C 用户手册

English - 41

A number of fault messages that can be shown by the red Fault indicator lamp on Husqvarna 
Automower™ are shown below. The fault message is interpreted by reading how the lamp flashes. The 
lamp flashes one to five times in quick succession and then goes out for 2 seconds. This sequence is 
repeated until the Cancel button is pressed. For example, three flashes in the table below corresponds to 
the lamp flashing three times in quick succession, and then going out.

Always try to restart the mower if the Fault indicator lamp is lit or flashes. Restart the mower by pressing 
the Cancel button, enter your PIN code and close the cover

If the same fault occurs frequently, or if the Fault indicator lamp is lit with a steady light: contact your 
dealer.

Wrong PIN code has been 
entered. Three attempts are 
permitted, the keypad is then 
blocked for five minutes.

Enter the correct PIN code.

The charger cable is not 
connected when changing the 
PIN code, or when connecting 
the mower to the loop 
generator/charger.

Connect the charger cable

The loop generator/charger is 
not connected to the mains 
supply or its miniature 
circuit-breaker has tripped.

Check the wall socket connection and 
whether the miniature circuit-breaker has 
tripped.
Reset the miniature circuit-breaker by 
removing the loop generator/charger's power 
cord from the wall socket, wait 10 seconds 
and then reconnect the power cord in the 
wall socket again.

Boundary wire broken.

Check the signal given by the LED on the 
loop generator/charger. If it flashes the loop 
is damaged. Repair the broken cable using 
an original waterproof coupler.

The connection between 
Automower and the charging 
station has been lost. 

Link the mower to the loop 
generator/charger by changing the PIN 
code, see page 30. You can use the same 
PIN code as earlier. You can use the same 
PIN code as earlier.

This may be due to the 
boundary wire being routed in 
the wrong direction around an 
”island”, which blanks out the 
signal.

Check that the boundary wire has been 
routed correctly.

If this occurs in isolated areas 
it may be due to interference 
from metallic objects 
(perimeter fence, 
reinforcement bar) or buried 
cables in the vicinity. 

Try moving the boundary wire.

Automower has got caught in 
something.

Free the mower and rectify the reason for 
the lack of drive. If it is due to wet grass, wait 
until the lawn has dried before using the 
mower.