Husqvarna 320 AWD 用户手册

28 – 

English

1

Remove the transmission cover. Undo the two screws 
(one on each side) and lift off the transmission cover.

2

Check that there is oil in the transmission’s oil tank.

Rider 318 Fill if necessary with engine oil SAE 10W/40 
(class SF–CC).

Rider 320 AWD Fill if necessary with oil Synthetic 10W/50

The oil and filter should be changed by an authorised service 
representative, as described in the Workshop Manual.

Work on the system entails particular demands on 
cleanliness and the system must be vented before the 
machine is used.

•

The belt adjuster should be lubricated regularly using 
good quality molybdenum disulphide grease*.

•

Lubricate using a grease gun, 1 nipple from the right-hand 
side under the engine’s lower belt pulley, until grease is 
forced out. With daily use, lubrication should be carried 
out twice weekly.

All joints and bearings are lubricated using molybdenum 
disulphide grease during manufacture. Continue to lubricate 
using the same type of grease *. Lubricate the steering and 
control wires using engine oil.

Carry out this lubrication regularly; with daily use, the 
machine should be lubricated twice weekly.

*Grease from well-known brand names (petrochemical 
companies, etc.) usually maintains a good quality. The most 
important property is that the grease provides good 
protection against corrosion.