Husqvarna 355FX 用户手册

English

 –

 17

•

Fit the holder (R) and bracket (J) with 2 bolts (H) on 
the gear housing.

•

Then fasten the blade guard (A) with 4 bolts (L) in the 
holder (N).

•

Fit the drive disc (B) on the output shaft.

•

Turn the blade shaft until one of the holes in the drive 
disc aligns with the corresponding hole in the gear 
housing.

•

Insert the locking pin (C) in the hole to lock the shaft.

•

Place the blade (D) and support flange (F) on the 
output shaft.

•

Fit the nut (G). The nut must be tightened to a torque 
of 35-50 Nm (3.5-5 kpm). Use the socket spanner in 
the tool kit. Hold the shaft of the spanner as close to 
the blade guard as possible. To tighten the nut, turn 
the spanner in the opposite direction to the direction of 
rotation (Caution! left-hand thread).

When loosening and tightening the saw blade nut, there is 
a risk of injury from the teeth of the saw blade. You should 
therefore always ensure that your hand is shielded by the 
blade guard when doing this. Always use a socket 
spanner with a shaft that is long enough to allow this. The 

arrow in the diagram shows the area where you should 
operate the socket spanner when loosening or tightening 
the nut.

•

Fit the holder (K) and bracket (J) with 4 bolts (H) on the 
gear housing.

•

Then fasten the shredder blade guard (A) with 4 bolts 
in the holder as shown.