Husqvarna CTH2542 TWIN 用户手册

NOTE: The strap hook must go through the discharge chute 

only. Do not allow the hook to enter the slot in the tractor 

back plate. This will allow the dis charge chute to float with the 

mower deck when moving on uneven terrain.

02306

•  Unfold bag by pivoting front bagger tube all the way 

forward and pressing the bottom vinyl binding onto the 

tube.

• 

Inside the bag, install spreader bars and retainer springs 

onto pins on both sides of bag as shown.

• 

Press the vinyl bindings onto the sides of front bagger 

tube.

•  Slide the bagger dump handle through the hole in the 

bagger top, install the clevis pin 10 x 44mm and secure 

with retainer spring.

•  Push cap over end of bagger dump handle.
NOTE: For future use, the clevis pin may be removed in order 

to use the handle to clear the chute in the event it has become 

clogged.

•  Using the nuts and flat washers removed from tractor 

back plate, install the bagger support tube to the back 

plate as shown. Tighten securely.

• 

Install the two upper support brack ets through the back 

plate and to the  chas sis, install the clevis pin 10x17mm 

and secure with retainer spring.

•  Assemble both support brackets to the outside of the 

bagger support tube using two each 3/8 x 63,5mm hex 

bolts13/32" I.D. flat washers and 3/8 locknuts from parts 

bag. Tight en securely.

•  Replace discharge chute into rear opening of tractor.  

Secure the chute with the two hook straps.

02330

02

59

0

For proper bag function and appearance, it may be nec-

 es sary to adjust the bagger assembly. There should be 6mm 

(1/4")-9mm (3/8") gap between the bagger top and fender 

and the bagger top surface should be even with the top 

surface of the fender. To adjust bagger position:

02

90

5

02

906

029

07