Husqvarna PZ29D BF 用户手册

8065-080

Tensioner body

1. 

Detent pin

2. 

Nut/spring assembly

3. 
Pump belt removal

MaINTeNaNCe

47

Check every 100 hours of operation. Check for severe 
cracking and large nicks.
NOTE: The belt will show some small cracks in normal 

operation.

Disconnect the negative cable from the battery.

1. 

Remove the rear engine guard.

2. 

Remove clutch belt guard.

3. 

Loosen, but do not remove, the bolt securing 

4. 

tensioner to the left gear box mount. Access the 
bolt through the back of the gear box mount.

Place an adjustable wrench on the tensioner body 

5. 

and slightly rotate the wrench clockwise to relieve 
pressure on the detent pin. With the pressure 
relieved from the pin, press in on the nut/spring 
assembly to compress spring and unlock the 
tensioner.
Remove belt from pulleys.

6. 

Place belt over gear box and clutch pulleys first 

1. 

and then over the idler pulley.
Place the adjustable wrench over the tensioner 

2. 

body and rotate clockwise until the detent pin 
locks into the notch in the tensioner body flange.
NOTE: Be sure the pin extends and locks 

completely into the tensioner. The end of the pin 
should be close to flush with the flange on the 
tensioner body.
Torque the tensioner body bolt to 60-64 ft/lbs.

3. 

Reinstall clutch belt guard and rear engine guard.

4. 

Connect negative battery cable to battery.

5.