Husqvarna Robotic Lawn Mowe 用户手册
Automower from
19
3. Installation
™
3.1 Preparations
1.
If the lawn in the proposed working area is taller
than 10 cm, mow it using a normal lawn mower.
Then collect the clippings.
than 10 cm, mow it using a normal lawn mower.
Then collect the clippings.
2.
Read carefully through all the steps before the
installation.
installation.
3.
Check that all parts for the installation are
included:
included:
• Operator’s Manual (26)
• Automower
• Charging station (15)
• Boundary wire (18)
• Transformer (19)
• Low voltage cable (20)
• Staples (21)
• Boundary wire connector (22)
• Nails (23)
• Measurement gauge (24)
• Boundary wire coupler (25)
During installation you will also need: A hammer to
knock the staples into the ground, combination pliers
and a straight spade if the boundary wire is to be
buried.
knock the staples into the ground, combination pliers
and a straight spade if the boundary wire is to be
buried.
3.2 Installation of the charging
station
station
Ideal position of the charging station
For examples of good positioning of the charging
station, see 7. Garden example - proposed installation
and settings on page 65.
station, see 7. Garden example - proposed installation
and settings on page 65.
If you are going to install a guide wire, read 3.8
Installation of the guide wire, see page 34, before
choosing the position of the charging station.
Installation of the guide wire, see page 34, before
choosing the position of the charging station.
3012-512