Husqvarna Rider 213 C 用户手册

English

 – 19

2

Check the tension of the steering wires by squeezing 
them together by the arrows as illustrated. It should be 
possible to push them together so that the distance 
between them is half as much, without using unnecessary 
force.

3

If necessary, the wires can be adjusted by tightening the 
adjuster nuts on each side of the steering collar. Do not 
over tighten the cables; they should only be drawn in 
towards the steering collar.

Hold the cable, for example using an adjustable wrench, 
so that it does not twist.

If you only tension one side the steering wheel’s centre 
position may change.

Check the wire tension on completion of the adjustment 
as per item 2.

Check that the brake is correctly adjusted by placing the 
machine on a slight downhill slope with the clutch disengaged 
and activating the brake.

When the machine does not stand still, the brake should be 
adjusted according to the following.

1

Loosen the locking nuts (1).

2

Tension the cable using the adjuster screw (2) until the 
play in the cable is taken up.

3

Tighten the locking nuts (1).

4

The brake should be checked again after adjustment

Check that the parking brake is adjusted correctly by placing 
the machine on a slope with the front and rear axles 
disengaged. Apply and lock the parking brake. When the 
machine does not stand still, the parking brake should be 
adjusted according to the following.

1

Remove the left-hand wing cover.

1

 Loosen the locking nuts (1).

2

Tension the cable using the adjuster screw (2) until the 
play in the cable is taken up.

3

Tighten the locking nuts (1).

4

The brake should be checked again after adjustment

5

Assemble the left-hand wing cover.

The throttle cable may need to be adjusted, if the engine does 
not respond as it should when accelerating, if it produces 
black smoke or maximum revs are not reached.

1

Release the clamping screw that secures the wire casing 
and set the choke control to maximum choke.