Husqvarna Rider 213 C 用户手册

20 – 

English

2

Pull the choke wire casing to the far right and tighten the 
clamping screw.

3

Pull back the throttle to the full throttle position and check 
that the choke is no longer actuated.

If the engine seems to lack power or does not run smoothly 
this may be because the air filter is clogged. It is therefore 
important to replace the air filter at regular intervals (see 
Maintenance/Maintenance Schedule for the correct service 
interval).

Replace the air filter as follows:

1

Open the engine cover.

2

Loosen the knobs holding the filter cover in place and 
remove it.

3

Remove the filter cartridge from the filter housing.

4

Remove the foam rubber prefilter which is placed around 
the filter cartridge and clean using a mild detergent.

5

Dry the pre-filter properly.

6

Refit the prefilter on the filter cartridge.

7

Slide the filter onto the air hose.

8

Push the filter cartridge in place.

9

Refit the air filter cover.

Replace the fuel filter every 100 running hours (once per 
season) or more frequently if it is clogged.

Replace the filter as follows:

1

Open the engine cover.

2

Move the hose clips away from the filter. Use a pair of flat 
pliers.

3

Pull off the filter from the hose ends.

4

Press the new filter into the ends of the hoses. If 
necessary apply liquid detergent to the ends of the filter to 
facilitate connection.

5

Push the hose clips back on the filter and tighten.

Check regularly that the fuel pump’s air filter is free from dirt.

The filter can when necessary be cleaned with a brush.

Do not use compressed air to clean the paper filter.

Do not oil the paper filter. They must be fitted dry.