Husqvarna Rider 213 C 用户手册

English

 – 25

Check the oil level in the engine when the Rider stands 
horizontal with the engine switched off.

Open the engine cover.

Loosen the dipstick, pull it up and wipe it off.

 The dipstick should be completely screwed down

Pull the dipstick out again and read the oil level.

The oil level should be between the markings on the dipstick. 
If the level is approaching the ADD mark, top up the oil to the 
FULL mark on the dipstick.

The oil is topped up through the hole the dipstick sits in.

Fill the oil slowly. Tighten the dipstick correctly before starting 
the engine. Start and run the engine at idling speed for 
approx. 30 seconds. Turn off the motor. Wait 30 seconds and 
check the oil level. If necessary fill so that the oil comes up to 
the FULL mark on the dipstick.

First and foremost use synthetic engine oil class SJ-CF 5W/
30 or 10W/30 for all temperature ranges. Mineral oil SAE30, 
class SF–CC can be used at temperatures > +5 °C (40 °F)

Do not mix different types of oil.

The engine oil should be changed the first time after 5 hours 
running time. It should then be changed after every 50 hours 
of running time.

When operating with a heavy load or at high ambient 
temperatures, replace every 25 hours.

1

Place a container underneath the engine’s left oil drain 
plug.

2

Remove the dipstick. Remove the drain plug from the 
engine’s left side.

3

Let the oil run out into the container.

4

Fit the drain plug and tighten it.

5

Fill with oil up to the ”FULL” mark on the dipstick The oil is 
topped up through the hole the dipstick sits in. See 
Checking the engine’s oil level for filling instructions.

6

Run the engine warm, then check that there is no leakage 
from the oil plug.

The oil filter must be replaced after every 200 hours running 
time. Turn the old oil filter anti-clockwise to remove. If 
necessary, use a filter remover.

Lightly lubricate the rubber seal on the new oil filter using new 
oil. Fit the oil filter by turning clockwise. Turn by hand until the 
rubber seal is seated. Now tighten a further half turn.

Fill with new oil according to Checking the engine’s oil level. 
Start the engine and let it idle for about 3 minutes. Now stop 
it and check for signs of leakage. Fill with oil to compensate 
for the oil held in the new oil filter.

Used engine oil, antifreeze etc. is a health hazard and must 
not be disposed of on the ground or in nature; it should 
always be disposed of at a workshop or appropriate 
disposal location.

Avoid skin contact; wash with soap and water in case of 
spills.